½” Threaded Insert
|
Standard threaded insert to fit inside ¾” tube. Ideal for wishbones
|
£1.75 |
|
|
½” Stepped Insert
|
Threaded insert that is stepped down to fit inside 16mm tube. Ideal for small wishbones or steering tie rods for junior specials
|
£1.75 |
|
|
5/8” unf Threaded Insert Short
|
Short threaded insert used on top wishbones |
£2.00 |
|
|
| 5/8” unf Threaded Insert Long |
Long threaded insert ideal for bottom wishbones or rear arm rose joint inserts |
£3.00 |
|
|
| ½”unf Top Shock Mount |
Threaded top shock mount that is tapered at one end to fit inside a shock bush , ideal for single sided shocker mounting |
£4.00 |
|
|
Wishbone D Lug
|
A D shaped lug to fit round standard roll cage tube , ideal for front wishbone brackets or chassis mounting brackets
|
£1.50 |
|
|
| Junior Special Tie Brackets |
These are shaped brackets to fit the tie rod mounting plates on the junior specials |
£4.00 |
|
|
| Junior Special Strut Plates |
These are the strut top plates to fit junior special struts (can also be used to make strut braces for nova/corsa) |
£2.50 |
|
|
| Rear Hub Plates |
A plate cut to fit inside our rear arm tubes. These come tapped M10 to take sierra hubs |
£5.00 |
|
|
| Rear Arm Tubes |
Tubes for the rear arms that take the drive hub. They are cut at the correct angle to enable a cv to be removed without the arm being taken off |
£10,00 |
|
|
Master Cylinder Mounting Brackets
|
brackets made to take standard master cylinders for making your own pedal boxes
|
£10.00 each |
|
|
Pedal Mount Brackets
|
Milled mounting brackets to hold pedals
|
£9.00 per set |
|
|
| Vauxhall Rear Hub |
Machined hub to weld into the rear arm tube. Allows you to use standard Vauxhall driveshafts and joints (no need for any adaptors etc.) Ideal for Class 5 and Class 9
Also available in a bolt-on version to fit existing arms. |
£50.00 each |
|
|
| Front Shock Brackets |
A machined bracket for the front shock mounts. Allows the ride height of the front of the car to be adjusted |
£10.00 each |
|
|
| Mounting Bush |
Counter bored mounting bushes for bike engines. Supplied for either M10 or M12 allen bolts (please specify when ordering) |
£2.50 each |
|
|
| Ally Spacer |
Ally spacers for shock and/or rose joint spacing. Available in either 5/8" or 1/2" (please specify when ordering) |
£1.00 each |
|
|
| Reducer Bush |
Reducer bushes for reducing the bolt size on rose joints. Available in either 3/4" to 5/8" or 5/8" to 1/2" (please specify when ordering) |
£1.50 each |
|
|
